Removing The Adjustable Foot Unit - Epson ELP-3500 Service Manual

3.2.14 Removing the Adjustable Foot Unit

Prerequisite: Complete the steps explained in sections 3.2.1, 3.2.4, 3.2.10, and 3.2.11.
1. Turn the adjustable foot counterclockwise about 40 times to remove it.
2. While pressing the foot lever, pull the foot axis upward to remove it.
3. Slide the upper side (foot lever side) of the compression spring to remove it.
4. Remove the foot lever pin then remove the foot lever
Caution:
When installing or removing the adjustable foot unit, do not fold or peel the foot seal on
the lower case. Insert the foot lever, then replace the counter spring, and finally insert the
foot axis. When installation is complete, press the foot lever to check whether it makes a
strange noise. If it makes noise, adjust the compression spring to change the contact
point with the foot lever to eliminate the noise.
Foot
Lever
Adjustable
Foot
Figure 3-24.
Foot
Lever Pin
Foot
Axis
Foot Lever
Figure 3-25.
3-20
EPSON ELP-3500 Service Manual
Compression
Spring