Set Re-Assembly; Lti/Cti Interface Panel Removal; Top Control Assy/Panel Removal; Pip Assy/Panel Removal - Philips 29PT5458/01 Service Manual

EN 8 4.
4.3.3

LTI/CTI Interface Panel Removal

Remove the LTI/CTI Interface panel from the Mono Carrier, by
disconnecting it from connector 1212.
4.3.4

Top Control Assy/Panel Removal

Notes:
•
PV02 styling: assy is mounted in the front cabinet;
•
FL13B styling: assy is mounted in the rear cover.
1. Remove the two fixation screws.
2. Push the assy a little bit upwards, and then pull it
backwards to release it from the front hinge.
3. Lift the panel from its bracket, while releasing the four
fixation clamps.
4.3.5
Linearity Assy/Panel Removal
Figure 4-4 Linearity assy/panel removal
1. Release the two fixation clamps [1] to lift the panel out of
the bracket [2].
4.3.6

PIP Assy/Panel Removal

1. Release the two fixation clamps to lift the panel out of the
bracket.
4.4

Set Re-assembly

To re-assemble the whole set, do all processes in reverse
order.
Note: before you mount the rear cover, perform the following
checks:
1. Check whether the AC power cord is mounted correctly in
its guiding brackets.
2. Check whether all cables are replaced in their original
position
L04E AA Mechanical Instructions
2
1
1
E_14480_051.eps
270204