Samsung HT-D550K User Manual page 20

Connections
Wireless Receiver Module (SWA-5000)
1. Press down the terminal tab on the back of the speaker.
2. Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
3. Connect the connecting plugs to the back of the product by matching the colors
of the speaker plugs to the speaker jacks.
4.
With the product turned off, insert the TX card into the
TX Card Connection (WIRELESS) on the back of the product.
~ Hold the TX card so that the label "WIRELESS" faces upward and insert the
card into the port.
~ The TX card enables communication between the product and the
wireless receiver module.
5. Connect the left and right surround speakers to the wireless Receiver module.
6. Plug the power cord of the wireless Receiver module in the wall outlet.
✎
NOTE
`
The rear speakers for HT-D550K/D553K/D555K can also be connected to the Wireless Receiver Module (SWA-5000) if you
purchase it separately.
`
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product,
some sound interruption may be heard due to interference.
`
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same
frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due to interference.
`
The transmission distance from the product to the wireless receiver modul e is about 33 feet (10m), but may vary depending on
your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the
system may not operate at all, because the radio wave cannot penetrate metal.
`
If the product doesn't make wireless connection, the product needs ID Setting between the product and wireless receiver module.
Insert the TX card in the rear of the product before entering Standby mode.
Press "0""1""3""5", and "5" using the numeric buttons on the remote control. You will see a message of "W INT" on the
screen.
`
With the wireless receiver module turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds.
!
CAUTION
`
Use the provided TX card only.
If a different TX card is used, the product may be damaged or the card may not be removed easily.
`
Do not insert the TX card upside down or in the reverse direction.
`
Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a problem.
`
If the TX Card is inserted and wireless receiver module setting is complete, sound is not output from the surround Speaker
connectors on the product.
`
The wireless receiver antenna is built into the wireless receiver module. Keep it away from water and moisture.
`
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any
obstructions.
`
If no sound is heard from the wireless receiver module, switch the mode to DVD 5.1 channel or Dolby ProLogic II .
`
In 2-CH mode, no sound will be heard from the wireless receiver module.
0
English
Red
Black
VIDEO VIDEO
SPEAKERS OUT SPEAKERS OUT
OUT OUT
DIGITAL DIGITAL
WIRELESS HDMI OUT HDMI OUT FA NET
AUDIO IN AUDIO IN (Only For Service) (Only For Service)
OPTICAL OPTICAL
AUX AUX COMPONENT COMPONENT
SURROUND SURROUND SUBWOOFER SUBWOOFER SURROUND SURROUND IN 2 IN 2 OUT OUT
WIRELESS
TX card
FM ANT