Advertisement
Quick Links
※ This Weatherproof IR Camera is
designed for Ceiling or Wall Mounting
Dimensions (mm)
126.0
122.0
150.0
75.0
Regulatory Notice
!
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1)This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against harmful interference in a
commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and use in accordance with the instructions, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause interference, in which case the user will be
required to correct the interference at his own expense.
WARNING - Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
CAUTION - When this camera is installed near equipment, like a wireless
communication device that emits a strong electromagnetic field, some
irregularity such as noise on the monitor screen may happen.
PRECAUTIONS:
!
Do not install the camera in extreme
temperature conditions.
Do use the camera under conditions where
temperatures are within -10°C to 45°C.
Be especially careful with ventilation under
high temperatures.
!
Do not install the camera under unstable
lighting conditions.
Severe lighting change or flicker can cause
the camera to work improperly.
!
Do not drop the camera or subject
to physical shock.
It can cause malfunctions to occur.
!
Never point the camera into strong
light or the sun.
It can damage CCD.
!
Note
If there is a bright spot light in the scene,
smearing or blooming may occur.
Confirm that the power supply provides
sufficient power before connecting the
camera.
Bright Adjustment V.R
1
Used to adjust video output level of DC driven auto iris lens.
When the brightness control of the monitor does not operate correctly,
you can optimize the picture picture by controlling the DC level of camera.
Simple to install
Outdoor
Surveillance Camera
COMPOSITION:
Operation Manual
SPECIFICATIONS:
Model
Signal System
Scanning System
Scanning Frequency (H)
Scanning Frequency (V)
Image Sensor
Total / Effective Pixels No.
S / N Ratio
Resolution
Video Output Level
Lens
Focus
Sync. System
Sensitivity (F1.2)
Electronic Shutter
White Balance
AGC/ BLC/ D&N/ FL
DSS
D-ZOOM
DNR
Input / Output Connector
Operrating Temperature
Storage Temperature
Power Consumption
Dimensions (WxHxD)
Weight
Call 1.800.796.CCTV for sales, service and customer support.
www.honeywellvideo.com
CONNECTION:
Connecting to Monitor and Power
#1
• The wire is polarized.
Video Output
Video
• Use 12VDC
(Yellow)
No.
Function
GND
#1
Video Output
Power- 12VDC
(Red)
#2
Power Input
#2
NAME AND FUNCTION:
1
3
2
4
4
5
5
As surroundings darken, it switches
automatically from color to black-and-white
mode to enhance sensitivity.
Sun Visor Fastener
L-Wrench
Bracket Mounting Screws
NTSC
PAL
NTSC : 525 Lines
PAL : 625 Lines
2 : 1 Interlace
15.734kHz
15.625kHz
59.94Hz
50Hz
1/3 inch SONY Super HAD CCD
410K
470K
50dB Min. (AGC Off)
550 TV Lines
1.0 Vp-p (75 Ohms, composite)
Vari-focal Lens (F=1.2, f=3.8~9.5mm)
Manual
Internal
0.3 Lux (color)/ 0.008 Lux (DSS On) / 0 Lux (IR LED On)
1/60 ~ 120,000 Sec.
1 /50 ~ 120,000 Sec.
Auto
On / Off Selectable
On / Off (Max 32 times)
On / Off (2 x)
AUTO
Power (Red Jack), Video (Yellow Jack)
-10°C ~ 45°C
-20°C ~ 65°C
12VDC (10V~15V), 0.3A/3.6W (Max)
75 x 78 x 150mm
Approx. 800g
Need Help?
12VDC Power Type
power source.
Terminal Color
Remark
Yellow
1.0 Vp-p
Red
12VDC(10V~15V), 0.3A(Max)
Vari-focal Lens Type
Photo Sensor
2
IR LED
3
850nm / 30°(18EA)
Zoom Handle
Used to adjust zoom magnification by
turning.
Focus Handle
Used to provide for accurate focusing
of object within the lens field of view.
HB73
Series
Operation
Manual
• 1/3" Sony Super HAD CCD
• High Resolution: 550 TV Lines
• Auto White Balance
• AGC, BLC, Flickerless On/Off
• 3.8 - 9.5 mm DC Vari-focal Auto Iris Lens
• Super Digital Noise Reduction (SDNR)
• Electronic Sensitivity-up(DSS) On/Off
• Weatherproof Housing
• IP65
CAMERA SET-UP:
a
Service Monitor Connecter:
b
Function Selection Switch:
Use service monitor connector
•BLC(Back Light Compensation)
to set camera angle & focus
ON/OFF
when installing.
•AGC(Auto Gain Control) ON/OFF
J504
•D/N(Day & Night) ON/OFF
VR501
•DSS(Digital Slow Shutter) ON/OFF
a
•D.Z(Digital Zoom) ON/OFF
•FLK(Flickerless) ON/OFF
CAUTION : When AGC is off,
ON
D/N does not work because the
D/N switching function is
J505
1 2 3 4 5 6
SW501
dependent on the AGC level.
b
TROUBLESHOOTING:
If you have trouble operating your camera, refer to the following.
If the guidelines do not enable you to solve the problem,
contact an authorized technician.
•
The image does not
Check the power source for the monitor and
appear on the screen.
camera and ensure that the voltage and polarity
are correct.
•
The image on the
Check if the lens is stained. If dirty, clean the lens with
screen is dim.
a soft, clean cloth.
•
Adjust the Back Focus of the lens again.
The camera does not work
•
Check if you have connected the camera to a proper
properly, the surface of the
power source and If there is no problem with the power,
camera case is hot, and a black
turn the unit off immediately and seek assistance from
line appears on the screen.
our Customer Service department.
The screen blinks a lot.
•
Check if the camera is pointed toward the sun or a
fluorescent lamp.
•
Adjust the angle or location of the camera if too much
light is coming into the screen.
READ AND KEEP THIS
OPERATION MANUAL
Advertisement
