Table of Contents
Advertisement
5
ADJUST CYCLE RATE
1st stage heating and 1st stage cooling cycle
rates are factory-set for heat pumps. The heat
pump compressor cycle rate cannot be adjusted.
To customize the thermostat's performance to
different types of heating equipment, however, a
cycle rate adjustment screw is provided on the back
of the thermostat to control the auxiliary heat cycle
rate. Correct setting of the screw will provide opti-
mum savings, See Fig. 6.
NOT USED
OUT 1/2
M9075
Fig. 6—Cycle rate adjustment.
COMPLETE INSTALLATION
1A
1B
AUXILIARY HEAT
1B
CYCLE RATE
3 CPH
SLOWER
IN
CYCLING
6 CPH
FASTER
TURN
CYCLING
NOTE: MOST APPLICATIONS DO NOT REQUIRE
A CHANGE IN CYCLE RATE.
The room air temperature normally varies
slightly from the comfort temperature setting with
the cycling of the heat pump or auxiliary heater.
INSTALL BATTERIES
Three AAA alkaline batteries are included with
the thermostat to prevent program loss in case of
power outage. Install batteries in back of thermo-
stat as shown in Fig. 7. Without battery backup, the
M3058
Fig. 7—Battery placement.
10
BATTERY PLACEMENT
(NOTE CORRECT PLUS
AND MINUS DIRECTION)
Advertisement
Table of Contents
