Installation Of Mirror Housing To Body Proper - Pentax ASAHI SPOTMATIC 23102 Service Manual

(6) When the hook release lever (02087) is
replaced with a new one, try to flip up the
mirror seat quietly with your finger to
check if (02087) will hit against the side of
the mirror seat prior to hitting on the hook
release stud A (02089). If it hits, file away
(02087) for adjustment.
(7) Check and maintain a proper clearance of
such parts as the mirror actuator lever top
(02018), mirror actuator lever bottom
(02019) and actuator lever A.
(02085) and dia actuator lever B (02086) in the shaft direction with use of washers. The dia actuator lever
A (02085) should be devoid of curvature as the side of the synchro seat (02026) serves as its stopper.
b. INSTALLTION OF MIRROR HOUSING TO BODY PROPER
Install the assembled mirror housing onto the body proper (01001) by screwing it with two mirror housing
retainer screws (02053) through the upper part of the body proper and with two screws, one (FM 1.7 x 3.5)
and one (SM 1.7 x 3.5), through the bottom part of (01001).
23102 Page 23