Nikon COOLPIX AW120 Quick Start Manual page 274

Display
Unable to correct
compass.
No access.
Could not connect.
Wi-Fi connection
terminated.
Lens error
Communications
error
System error
Cause/Solution
Unable to calibrate the electronic compass.
Swing the camera to draw a figure eight in the
air outdoors while turning your wrist to face the
camera forward and backward, side to side, or
up and down.
The camera could not receive the
communication signal from the smart device.
Select Connect to smart device in the Wi-Fi
options menu, and wirelessly connect the
camera and smart device again.
The camera failed to establish the connection
while receiving the communication signals
from the smart device. Select a different
channel in Channel in Options in the Wi-Fi
options menu and establish the wireless
connection again.
A cable was connected to the camera while the
camera and smart device were wirelessly
connected, the battery level became low, or the
connection was aborted due to poor
connectivity. Check the status of the camera
and establish the wireless connection again.
A lens error occurred.
Turn the camera off and then on again. If the
error persists, contact your retailer or Nikon-
authorized service representative.
An error occurred while communicating with
the printer.
Turn the camera off and reconnect the USB
cable.
An error occurred in the camera's internal
circuitry.
Turn the camera off, remove and reinsert the
battery, and turn the camera on. If the error
persists, contact your retailer or Nikon-
authorized service representative.
A
E89
90,
E92
90,
E92
90,
E92
22
E23
12, 22
E97