Troubleshooting - Honeywell RCWL200A Installation Instructions Manual

Troubleshooting

Two 'beep' sounds are heard and LED flashes twice after the normal chime sound...
This indicates a low battery in the chime. Install new batteries, type LR14 C size alkaline batteries.
Three 'beep' sounds are heard and LED flashes three times after the normal chime
sound...
This indicates a low battery in the bell push that activated the chime. Install a new battery, type
CR2032.
When the bell push is operated, the red confidence light does not turn on, or is only on
for a short time...
Low battery. Install a new battery, type CR2032.
The chime does not work...
• Check that the batteries are the correct type.
Only use alkaline batteries for chime.
• Check that the batteries are fitted correctly (no wrong polarity).
• Check that batteries are not loose.
• The chime could be out of range of the bell push. Try the chime in a different location.
• The chime might not have learned the identity of the bell push. Follow the programming
procedure in step 3.
Note: Do not press program button for more than 15 seconds, this will delete all the memory!
Repeat programming procedure in step 3 to restore operation.
69-2112EFS_D.indd 9
RCWL200A and RCWL210A
9 69-2112EFS—07
12/10/2009 12:05:45 PM