Table of Contents
Advertisement
Installation
Mounting a Lens
1. Remove the protective cap in front of the camera.
2. Confirm the mount ring whether it is for C or CS. * Caution1
3. Attach the lens to the lens mount ring.
4. If the lens has an Auto Iris mechanism, connect the iris cable to the Lens connector
(EE/VSD S/W must be set to VSD on the side of the camera)
A. In the case of having no iris amplifier : Set the slide switch to DC (Down side)
B. In the case of having iris amplifier : Set the slide switch VSD (Upper side)
C. Set the S/W on the side of the camera to DC or VSD, too.
☞ If using lens that has iris amplifier, "LEVEL" and "ALC" volume of lens must be
adjust carefully. It may cause any hunting.
☞ When connecting Auto iris lens, be sure to use the connector to be recommended
by manufacturer. (E4-191, Chuo Musen, Japan)
* Caution 1 : This appliance is set to CS mount default.
If you want to use C mount lens, fix a C adapter ring additionally packed
in the box.
When Auto-Iris Lens is used...
VSD LENS PIN CONFIGURATION
3
4
1
2
1. POWER(12V)
3. VIDEO SIGNAL
Set the select switch to VSD
* For the best condition, read lens manual carefully .
* After connecting Auto iris-lens you may need to set flange back focus.
Connection of AC power supply
☞ Must be checked the power source from the external power supply before power on.
☞ Recommended power source capacity :
AC 24V, more than 500mA
①③
②
④
2. NO CONNECTION
4. GND
DC IRIS LENS PIN CONFIGURATION
4
3
1
2
1. CONTROL-
2. CONTROL+
3. DRIVE+
4. DRIVE-
Set the select switch to DC
① ③
②
④
5
5
6
6
Advertisement
Table of Contents
