Netgear Genie Setup - NETGEAR Trek PR2000 User Manual

• Wireless network key or password. Your Trek is preset with a unique wireless network
name (SSID) and password for wireless access. This information is on the product label.

NETGEAR genie Setup

NETGEAR genie runs on any computer or device with a web browser. It is the easiest way to
set up the Trek because it automates many of the steps and verifies that those steps have
been successfully completed. It takes about 15 minutes to complete.
To use NETGEAR genie to set up your Trek:

1. Turn on the Trek by moving the Internet via switch to one of the following positions:
• Wired. For an Internet connection with an Ethernet cable
• Wireless. For a wireless Internet connection
For information about the Internet via switch, see
2. Make sure that your Trek is cabled correctly.
If you want to connect to the Internet with an Ethernet cable, make sure that you have
connected an Ethernet cable between the Internet/LAN port of the Trek and the Ethernet
port of your DSL or cable modem. For more information, see
Home Setup on page 19.
3. Make sure that your device is connected with an Ethernet cable to your Trek.
You can also connect your device wirelessly to your Trek. For more information, see
Wireless Devices or Computers to Your Trek
4. Launch your Internet browser in one of the following ways.
• The first time you set up the Internet connection for your Trek, the browser
automatically goes to www.routerlogin.net, and the NETGEAR genie screen
displays.
• If you already used the NETGEAR genie, type www.routerlogin.net in the address
field for your browser to display the NETGEAR genie screen. See
genie After Installation
5. Follow the instructions on the screen to complete the NETGEAR genie setup.
NETGEAR genie guides you through connecting the Trek to the Internet. For more
information about your Internet connection choices, see
to the Internet
6. If the browser cannot display the web page, do the following.
• Make sure that the computer is connected to the LAN Ethernet port or wirelessly to
the Trek.
• Make sure that the Trek is running. If it is, its WiFi LED is lit.
• Close and reopen the browser to make sure that the browser does not cache the
previous page.
• Browse to www.routerlogin.net.
Trek N300 Travel Router and Range Extender PR2000
on page 28.
on page 15.
Get Started with NETGEAR genie
Internet Mode Switch
Internet Connection at
on page 32.
Different Ways You Can Connect
27
on page 10.
Add
Use NETGEAR