Table of Contents
Advertisement
Customer service & product warranty – Australia and New Zealand
You cannot hear a ring tone/dialling tone
from the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied
or ensure that the pin connections are cor-
rect when purchasing from a retailer
¢
(
page 9).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000
¢
(
page 67).
Forgotten the system PIN.
¥
Reset the system PIN to 0000
¢
(
page 67).
The other party cannot hear you.
You have pressed the
The handset is "muted".
¥
Activate the microphone again
¢
(
page 28).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to release Calling Line Identification (CLI).
You hear an error tone when keying an
input (a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your PABX is set for dial pulsing.
¥
Set your PABX to touch tone dialling.
72
display key.
§Mute§
Gigaset SL785 only
No time is specified for a message in the
calls list.
Date and time have not been set.
¥
Set the date/time (
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥
Enter the system PIN again.
2. The system PIN is still set to 0000.
¥
Change the system PIN (
The answering machine is not recording any
messages/has switched over to answer only.
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.
¢
page 14).
¢
page 67).
Advertisement
Table of Contents
