Service Position; D And G Board Removal; Side Control Module Removal; H2 Board Removal - Sony FD Trinitron KV-29LS60B Service Manual

2-4. Service Position

Position the chassis as indicated to access the solder side.
To gain access to the underside of the boards follow the
instructions on page 15. [Removal and Replacement of the
main bracket bottom plates ].

2-6. Side Control Module Removal

Screws
Remove the two screws fixing the user control module to the
side of the set. The control module can then be removed by
sliding it towards the rear of the set allowing access to the H2
Board.

2-5. D and G Board Removal

To remove the G Board release the clips circled and ease the
board gently away from the support bracket. Removal of the
D Board follows the same procedure.

2-7. H2 Board Removal

To remove the H2 Board release the two clips circled and ease
the board gently away from the support bracket.
- 12 -
Clips
Clips