Focus; White Balance - Sony Trinitron KV-25FX20A Service Manual

(3) Screen corner convergence.
• If you are unable to adjust the corner convergence properly,
correct them with the use of permalloy assemblies.
a
a-d: screen-corner
convergence defect
c
Install the permalloy assembly
for the area that needs correcting
b
d
b
d
a
.
c

Focus

Screen
3-3. FOCUS
1. Receive a television broadcast signal.
2. Normalise the picture setting.
3. Adjust the focus control on the flyback transformer for the
best focus at the centre of the screen.
Bring only the centre area of the screen into focus, the magenta
ring appears on the screen. In this case, adjust the focus to
optimize the screen uniformly.

3-4. WHITE BALANCE

G2 Screen Adjustment
1. Switch the TV set into AV mode [apply a cross-hatch signal].
2. Enter into the 'Service mode' and select 'Picture Control'.
3. Enter 'Picture Control' and select 'Personal' press OK.
4. Return to 'Picture Control' menu and select 'Reset'.
5. Measure the voltages on the 3 cathodes of the CRT, Kr,Kg
and Kb using an oscilloscope with a 100:1 probe.
6. Connect the oscilloscope to the CRT cathode which recorded
the highest voltage and adjust [RV702 SCREEN] located on
the C Board to obtain a reading of 175V.
White Balance Adjustment
1. Input an all white signal from the pattern generator.
2. Enter into the Service Mode.
3. Enter into the 'Picture Adjustment' service menu.
4. Select 'Sub contrast' and adjust to 7.
5. Select the 'Green drive' and adjust so that the white balance
becomes optimum.
6. Select the 'Blue drive' and adjust so that the white balance
becomes optimum.
7. Press the 'TV' button on the remote commander to return to
TV operation.
PICTURE ADJUSTMENT
AFC mode
REF position
SCP BGR
SCP BGF
Trap fo
Sub contrast
Sub colour
Sub brightness
Sub hue
Green drive
Blue drive
Green cutoff
Blue cutoff
Gamma
Pre / overshoot
Y delay
19
1
2
1
1
0
Adj
Adj
Adj
Adj
Adj
Adj
Adj
Adj
0
0
3