9-1) Source Power Circuit; 9-2) Oscillator Circuit; 9-3) Reset Circuit - Samsung RS 24 Service Manual

Circuit Descriptions

9-1) Source Power Circuit

This circuit shows SMPS(Switch Mode Power Supply) which converts AC input voltage to a high DC voltage. The input
AC source power is converted to DC through a wave rectifier (BD1) and the converted DC power will generate a constant
waveform on the switching transformer using a high speed (100KHz) switching motion of TOP223Y. The D104 will rectify
the generated voltage and transform into a steady 12V DC source power used for the digital display panel and relays.
The regulator (KA7805) finally transforms into 5V DC source power for the control board and sensor's circuits.
Caution) Be careful to handle this circuit due to high voltages (AC115V, DC170V)

9-2) Oscillator Circuit

This is oscillator circuit to generate synchronous clocks used to calculate the time for the microprocessor operation.
Note) If the specification of a resonator changes, micro-processor can not work properly.

9-3) Reset Circuit

The reset circuit is to initialize the values RAM ＆ other sectors of micro-processor. When the power is engaged initially,
the reset voltage becomes "Low," and it keeps "High" in the normal operation.
Terminal
Xin(#30)
Xout(#31)
Terminal
Vcc
RESET
38
Oscillation Frequency
4MHz
4MHz
Voltage
DC 5V
DC 5V