Replacing The Projection Lamp (Single Lamp) - InFocus F5500 User Manual

For IN5504 and IN5502 (Single Lamp)
1
Turn the projector off and unplug the power cord.
2
Wait 60 minutes to allow the projector to cool thoroughly.
3
Remove the lamp door:
(a) release the top latches by sliding the release buttons toward the rear
of the projector
(b) slide the top front cover towards the direction of the lens,
(c) remove the 5 screws, then lift the lamp door off.
4
Loosen the 2 captive screws that attach the lamp housing to the projec-
tor. Carefully remove the lamp housing. Dispose of the lamp in an envi-
ronmentally proper manner in accordance with local disposal laws.
5
Install the new lamp housing and tighten the 2 screws.
6
Replace the lamp door by securing the 5 screws.
7
Replace the top front cover by sliding it back into place.
8
Plug in the power cord and press the Power button to turn the projector
back on.
9
To reset the lamp hour timer, navigate to the Status and Service menu and
select Reset Lamp Hours. See page 33 for details.
(3b)
(3a)
43
Turn off and
unplug projector
(3c)
SP-LAMP-055
(4)
(3a)
Wait 60
minutes