JVC VN-T16U Instructions Manual page 10

Power supply

Please make sure the power source is DC12V / AC24V / PoE. Only connect the camera to this power
system.
When using AC24V power supply, do not connect the AC24V cable to commercial power supply. If it is
connected by mistake, the internal circuit may be damaged. Do not use the camera and make sure to
send it to the nearest JVC dealer for inspection.
Real time clock

The real time clock of the camera will be initialized by power off over 3 days. In such case, please set da-
ta/time manually, or set NTP server. If the real time clock is initialized, event log, data in SD card, and mail
sent by the camera do not show correct time.
SD card

SD card is fragile and not reliable for long term use. Our company will not be liable for damages resulting
from the use of SD card. Frequent back up of data is recommended. Data of SD card will be lost by trou-
bles below.
Electrical or Mechanical Shock to SD card.

Power off or ejecting of SD card during recording.

Rewriting times exceeds upper limit of the SD card (The upper limit depends on grade of the SD

card.)
Energy Conservation

When the camera is not in use for a long time, turn off the power for safety and energy conservation
reasons.
Copyright Protection

With the exception of the user being the copyright holder or when permission such as for du-

plication has been granted by the copyright holder, permission is required in principle for the
duplication, modification, or transmission of copyrighted material.
Unauthorized duplication, modification, or transmission of copyrighted material may constitute a

copyright infringement, and the user may be liable to compensate for any damages. When using
copyrighted material, be sure to check the license agreement of the copyrighted material thor-
oughly.
When rights or rights holders are involved with regard to the targeted duplicating subject, per-

mission may be required for shooting or using (processing) it. Be sure to check the licensing
conditions thoroughly.
Disclaimer

We will not be responsible for any inconveniences or disturbances caused in the event of privacy invasion
as a result of camera footages of this product.
Others

Because the camera controls auto exposure by shutter speed, flicker can be shown by fluorescent light.
To reduce the flicker, please select PAL mode if the power is 50Hz, or NTSC mode if the power is 60Hz.
(Refer to INSTRUCTIONS "4 Overview of Navigation and Controls" - "Video Type").
9