Dvd 5 1 Ch/7 Lch (5 1 Ch For Vsx-D710S) Input Playback 3; Midnight Listening Mode; Playing Other Source 3 - Pioneer VSX-D710S Operating Instructions Manual

Sound Modes
DVD 5.1 chJ7.1 ch (5.1 ch for VSX-
D710S) input playback
If you want you can connect a component with 7 1
channel (5 1 channel for VSX-D71OS) analog output to
enjoy surround sound playback In this case the
surround sound will be externally decoded and then fed
into the receiver
DVDILD
MULTICONTROL
RCV
5 II7 1
To switch on DVD 7 1 ch (5 1 ch for VSX-
D710S) mode press the
DVDlLD MULTI
CONTROL
button on the remote, then
RCV,
then 5.117.1 button
VSX-D710S only: On the main unit press the
DVD 5 ICH button to switch on 5 1 ch mode
Press the 5
l/7.1
button on the remote to go
back to the DVD/LD mode If you're using
the main unit, choose any other function
with the
MULTI JOG
MEMO:
When 5 1 ch/7 1 ch input is selected, Dolby mode,
DSP mode, SIGNAL SELECT, ATT, DIRECT, TONE,
MIDNIGHT mode, LOUDNESS and speakers B
cannot be operated
When 5 1 ch/7 1 ch input is selected, only the
volume level and channel levels can be set
MIDNIGHT listening Mode
When listening at low volume, surround effects tend to
become less than satisfactory Turn the MIDNIGHT
listening mode on to enjoy the effects of quality
surround sound even at low volumes This mode allows
you to hear effective surround sound of movies at low
volume levels
1 Press
RCV
This sets the remote to select the sound mode
(You
can skip this step when using the controls on
the receiver >
2 Press MIDNIGHT
Each press switches MIDNIGHT listening mode on or
off
MEMO:
l
The effect automatically adjusts according to the
volume level
Playing other Sources
2
3
4
Turn on the power of the playback
component
Turn on the power of the receiver
Be sure that the standby indicator turns off on the
front panel
Press
MULTI CONTROL
buttons or the
FUNCTION
button to select the source you
want to playback
If the DIRECT FUNCTION is OFF you have to use
the FUNCTION button to select the source (see
p 39)
If necessary, press
SIGNAL SELECT
to select
the input signal corresponding to the source
component (see p 29)
Start playback of the component you
selected in step 1
31
En