Using The Leather Recharging Case - Brookstone Leather Recharging Case Instruction Manual

UsInG The leaTheR RechaRGInG case

Make sure the Leather Recharging Case is fully charged before use .
1 . Slide the item to be charged straight onto the PIN CONNECTOR until secure .
2 . Slide the POWER SWITCH on the Leather Recharging Case to the UP position
to charge the item . The LED POWER SWITCH will illuminate red while charging .
3 . When item is done charging and the LED POWER SWITCH's red light turns off,
remove the item from the Leather Recharging Case by sliding it straight up .
4 . When the Leather Recharging Case's charge is low, the item being charged will
show a "no battery" icon on its screen to indicate you need to recharge the battery
in the Leather Recharging Case .
important: do not pull the item being charged out of the leather recharging Case
at an angle! this may damage either the unit being charged, the leather recharging
Case Pin ConneCtor, or both (please see Figures 1 and 2 below).
7
Figure 1 Figure 2