Onboard Headers And Connectors - ASROCK FM2A88M Extreme4+ User Manual

2.6 Onboard Headers and Connectors

Serial ATA3 Connectors
(SATA3_1: see p.2, No. 16)
(SATA3_2: see p.2, No. 17)
(SATA3_3: see p.2, No. 15)
(SATA3_4: see p.2, No. 14)
(SATA3_5: see p.2, No. 13)
(SATA3_6: see p.2, No. 12)
(SATA3_7: see p.2, No. 10)
(SATA3_8: see p.2, No. 11)
USB 2.0 Headers
(9-pin USB_5_6)
(see p.2 No. 21)
(9-pin USB_7_8)
(see p.2 No. 22)
(9-pin USB_9_10)
(see p.2 No. 23)
USB 3.0 Header
(19-pin USB3_3_4)
(see p.2, No. 8)
22
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
SATA3_2
SATA3_1
USB_PWR
P-10
P+10
GND
1
GND
P+9
P-9
USB_PWR
Vbus
IntA_P3_SSRX-
IntA_P3_SSRX+
GND
IntA_P3_SSTX-
IntA_P3_SSTX+
GND
IntA_P3_D-
IntA_P3_D+
These eight Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
SATA3_4
SATA3_3
Besides four default USB 2.0
ports on the I/O panel, there
are three USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
DUMMY
Besides two default USB 3.0
Vbus Vbus
ports on the I/O panel, there is
IntA_P4_SSRX-
IntA_P4_SSRX+ one USB 3.0 header on this
GND
motherboard. This USB 3.0
IntA_P4_SSTX-
IntA_P4_SSTX+
header can support two USB 3.0
GND
ports.
IntA_P4_D-
IntA_P4_D+
DUMMY