Chevrolet Sonic 2014 Owner's Manual page 277

Caution
Allowing the wiper arm to touch
the windshield when no wiper
blade is installed could damage
the windshield. Any damage that
occurs would not be covered by
your warranty. Do not allow the
wiper arm to touch the windshield.
To replace the windshield wiper
blade:
1. Pull the windshield wiper
assembly away from the
windshield.
2. Squeeze the tabs on each side
of the wiper blade assembly and
slide the assembly off the end of
the wiper arm.
3. Install the new blade onto the
arm and make sure the tabs are
fully set in the locked position.
4. Repeat the steps for the other
wiper.
Rear Wiper Blade Replacement
Vehicle Care
1. Pull the wiper arm a short
distance away from the
glass (1).
2. Pull the blade out from
the arm (2).
It may require extra effort to
remove the old blade.
3. Once the blade pin disengages
from the wiper arm, remove the
wiper blade by sliding the pin out
of the guide hole.
4. Reverse the steps to install the
new blade.
10-27