Propeller - Honda Outboard Motor BFl15A Owner's Manual

10. MAINTENANCE
Propeller
THRUST
If the propeller is damaged by striking
a
rock, or other obstacle, replace the
propeller as follows.
-
l
Before replacing the propeller,
remove the engine switch key
to prevent accidental engine
starting.
l
The propeller is thin and sharp.
To protect your hands, wear
the heavy gloves during
replacement.
108
PIN
PdPELLER
NUT
Replacement
1. Remove the cotter pin then remove
the 18,5 mm castle nut, 19 mm plain
washer, propeller and thrust washer.
2. Install the new propeller in the reverse
sequence to removal. Be sure to replace
the cotter pin with new one.
NOTE:
l
Install the thrust washer with the
grooved side toward the gear case.
l
Use a genuine Honda cotter pin and
bend the pin ends as shown.