Check Your Work Area - Honda Harmony HS520A Owner's Manual

BEFORE OPERATION
Check the General Condition of the Snowthrower:
• Look around and underneath the snowthrower for signs of oil or
gasoline leaks.
• Check the auger housing and the discharge chute for accumulation
of packed snow or ice. Clean the auger housing and discharge
chute before starting the snowthrower.
• Look for signs of damage.
• Check each control for proper operation.
• Check the scraper bar for wear. Replace it if necessary (page29).
• Check that all nuts, bolts, screws are tightened.
Check the Engine
• Check the oil level (page23).
• Check the fuel level (page22). Starting with a full tank will help to
eliminate or reduce operating interruptions for refueling.

CHECK YOUR WORK AREA

For your safety and the safety of others, always inspect the area
before operating the snowthrower.
Objects
Anything which can be picked up by the auger and thrown is a
potential hazard to you and others. Look for things like stones, sticks,
nails, and wire, and remove them from the work area.
People and Pets
People and animals near the work area can move into your
snowthrowers path or into a position where they could be struck by
thrown objects. Clear the area of people, especially children and pets.
Their safety is your responsibility.
Work Area
Check the condition of the snow. Adjust your snowthrower ground
speed and snowblowing swath accordingly.
Check the scraper bar for proper adjustment. Check the scraper bar
for the correct auger ground clearance (page30).
12