Camera Protocol - Televic D-CERNO Installation And User Manual

D-Cerno Wired System

16. Camera protocol

First set the correct destination IP address and port.
The port number has to be higher than 3000. For
example 9050 is a valid port.
The content is sent using the UDP packet protocol
and it is given in the following format (the * are
substitute for the real values, see further examples):
{"serial": "********","status": *,"totalMicOn":
*,"totalMicReq",*}
"serial" contains the serial code of the delegate unit.
This code is shown at the back of each delegate unit,
as the 8-digit number just under the barcode.
The "serial" data of a D-Cerno D delegate unit starts
with "10......"
The "serial" data of a D-Cerno C chairman unit starts
with "11......"
"status" has several options:
0 = off
1 = on
2 = request
4 = next in line
8 = prior
"totalMicOn" = total number of active microphones.
"totalMicReq" = total number of microphones in
request.
Televic Conference Systems
So for example if the microphone with serial
"101008D2" goes into request mode the following
command is send:
{"serial": "101008D2","status": 2,"totalMicOn":
1,"totalMicReq",0}
After a microphone conference mode change the
following string is sent:
{"serial": "00000000","status": 0,"totalMicOn":
0,"totalMicReq",0}
V0.4 - December 6, 2012
Installation and User Manual
59