Board - Sony MVC-CD250 Service Manual
Digital still camera
Hide thumbs
Also See for MVC-CD250:
- Operating instructions manual (132 pages) ,
- Specifications (2 pages) ,
- Operating instructions manual (133 pages)
Table of Contents
Advertisement
MVC-CD250/CD400
2-7. SY-76 BOARD
5 FP-488 flexible board
(CN901)
2 FP-481 flexible board
(CN721)
6 Ferrite core
3 FP-483 flexible board
(CN717)
4 FS-141 harness
[SERVICE POSITION (SY-76 BOARD: SIDE B)]
Setting the "Forced Power ON mode"
[Forced CAMERA mode]
1) Select page: 0, address: 01, and set
data: 01.
2) Select page: D, address: 2F, set data:
00, and then press the PAUSE button
of adjustment remote commander.
3) Select page: D, address: 21, set data:
07, and then press the PAUSE button
of adjustment remote commander.
4) Turn the power off, then on again.
DC-IN
CPC-9 jig
(J-6082-393-C)
(Note 1, 2)
18
1
A
Lens block assembly
B
(MVC-CD400)
A
B
Lens block assembly
(MVC-CD250)
7 Harness (microphone)
(CN902)
1 Control switch block
(CN720)
qs Flexible board
(base unit) (CN902)
8 Screw (M2)
(CN001)
[Forced PLAY mode]
1) Select page: 0, address: 01, and set
data: 01.
2) Select page: D, address: 2F, set data:
00, and then press the PAUSE button
of adjustment remote commander.
3) Select page: D, address: 21, set data:
08, and then press the PAUSE button
of adjustment remote commander.
4) Turn the power off, then on again.
AC power
adaptor
Adjustment remote
commander
18
1
SY-76 board
Note: Don't pull at harness of
connector.
9 Two claws
qa SY-76 board
A
Note 1: Don't use the 12 pin flexible board of CPC-9 jig.
It causes damage to the unit.
B
Note 2: The old CPC-9 jig (Parts code: J-6082-393-B) Cannot be used,
because it cannot operate the adjustment remote commander.
Note 3: Must be pressed lid open/close detect switch (S307, S308 on
PK-65/66 board) when using the CD-R/RW drive unit.
2-6
0 Four claws
Exiting the "Forced Power ON mode"
1) Select page: 0, address: 01, and set
data: 01.
2) Select page: D, address: 2F, set data:
E0, and then press the PAUSE button
of adjustment remote commander.
3) Select page: D, address: 21, set data:
00, and then press the PAUSE button
of adjustment remote commander.
4) Select page: 0, address: 01, and set
data: 00.
S307, S308
(Note 3)
Side cabinet block assembly
Monitor
Advertisement
Table of Contents
