Serial Trigger Mode; Read Time-Out; Presentation Mode - Honeywell Vuquest 3310g User Manual

less range than Normal mode. Enhanced mode is best used when you require
a very fast scan speed and don't require a long working range. Default = Man-
ual Trigger-Normal.
* Manual Trigger - Normal

Serial Trigger Mode

You can activate the scanner either by pressing the trigger, or using a serial trig-
ger command (see
the scanner scans until a bar code has been read or until the deactivate com-
mand is sent. The scanner can also be set to turn itself off after a specified time
has elapsed (see

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the scanner's trigger
when using serial commands to trigger the scanner. Once the scanner has
timed out, you can activate the scanner either by pressing the trigger or
using a serial trigger command. After scanning the Read Time-Out bar
code, set the time-out duration (from 0-300,000 milliseconds) by scanning
digits on the
Save. Default = 30,000 ms.

Presentation Mode

Presentation Mode uses ambient light to detect bar codes. The LEDs remain
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code. If the light level in the room is not high enough, Presen-
tation Mode may not work properly.
3 - 6
Trigger Commands
Read Time-Out, which follows).
Programming Chart
Read Time-Out
Presentation Mode
Manual Trigger - Enhanced
on page 11-4). When in serial mode,
inside the back cover, then scanning