(TROUBLE 5) No microwave oscillation even though oven lamp and fan motor run.
(Display operates properly)
CONDITION
Output is full power
when you set lower
power level.
NOTE: • Make sure the wire leads correct position.
• When Removing the wire leads from the parts, be sure to grasp the connector, not the wires.
• When removing the magnetron, be sure to install the magnetron gasket in the correct position
and in good condition.
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
CHECK
Disconnect the
Abnormal.
wire leads from
relay 2 and check
continuity relay 2.
(Operate the unit)
RESULT
Defective PCB
assembly.
5-16
CAUSE
REMEDY
Replace PCB
assembly.
LGE Internal Use Only