Table of Contents
Advertisement
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during tool operation. If operation is dusty, also
wear a dust mask.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from spark
plug. Failure to follow these instructions can result in
serious personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or de-
stroy plastic which may result in serious personal injury.
You can often make adjustments and repairs described here.
For other repairs, have the trimmer serviced by an authorized
service dealer.
EZ LINE
TAP ADVANCE SYSTEM
™
SPOOL REPLACEMENT
NEW PREWOUND SPOOL
See Figures 7 - 8.
If replacing string only, refer to String Replacement later
in this manual.
Use only .080 in. (2.0 mm) diameter monofilament string.
Use the manufacturer's replacement parts for best perfor-
mance.
Stop the engine, disconnect the spark plug wire or dis-
connect from the power supply. Hold the string head and
unscrew the spool retainer. Turn clockwise.
Remove the empty spool from the string head. Use the
spring from the empty spool if one is not provided with
the new spool and string.
To install the new spool, make sure the two strings are
captured in the slots opposite each other on the new
SPOOL
RETAINER
SLOTS
EYELETS
SHAFT
spool. Make sure the ends of each string is extended
approximately 6 in. beyond each slot.
Thread the strings into the eyelets in the string head.
Carefully push the spool into the string head (gently pull
the strings to the outside if necessary). When the spool
is positioned in the string head, grasp the strings and pull
sharply to release them from the slots in the spool.
Push down and turn the spool counterclockwise until it no
longer turns. Hold the spool down and rotate clockwise
a small amount. Release the spool. The spool should be
locked down in the string head. If not, hold down and
rotate until locked.
Make sure the string head and the spool retainer are
installed on the shaft by turning the retainer counterclock-
wise to tighten.
Pull the strings again to rotate the spool into cutting
position. Push the spool retainer down while pulling on
string(s) to manually advance the string and to check for
proper assembly of the string head.
10
Fig. 7
SPRING
STRING HEAD
Fig. 8
Advertisement
Table of Contents
