Yamaha RX-V800 Service Manual page 13

• Functions in DIAG mode
In addition to the DIAG menu items, functions as listed below are available.
• Input selection, 6CH input
• REC OUT (ZONE2) switching
• Center/Rear/Sub-woofer level adjustment
• Muting
• Speaker relay A/B
• Power on/off
• Master volume
It is possible to set to the following volume values directly by transmitting remote control codes during the DIAG operation
only.
Volume value (dB) Remove control
code
0 7A-E0
-20 7A-E1
-30 7A-E2
MUTE 7A-E3
* Functions related to the tuner and the set menu are not available.
* It is possible to confirm Menu No.11 IF STATUS while keeping the signal process (operation status) of each DIAG menu
by using the input mode key of the main unit.
• Initial settings used to start DIAG
Following initial settings are used when starting DIAG.
When DIAG is canceled, these settings are restored to those before starting DIAG.
• Master volume: -40dB
• Input, ZONE2 input: DVD (6CH INPUT OFF)
• Center/Rear/Sub-woofer level: 0dB
• Audio mute: OFF
• Speaker relay A/B: ON
• Speaker setting: LARGE / BASS OUT = BOTH
• DIAG menu: DSP through (analog bypass)
Remote control
key
PAGE A
PAGE B
PAGE C
PAGE D
RX-V800/RX-V800RDS/HTR-5280
12