Page 1
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page i V-2 MILLION POWER SERIES S P O T L I G H T ™ INSTRUCTION MANUAL Catalog Number SL212B Thank you for choosing Black & Decker! Go to www.BlackandDecker.com/NewOwner to register your new product BEFORE RETURNING THIS PRODUCT FOR ANY REASON PLEASE CALL 1-800-544-6986...
Page 2
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 1 GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES READ ALL INSTRUCTIONS WA R N I N G : Read all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 2 • EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.
Page 4
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 3 • Do not immerse spotlight in water. • Do not drop or throw spotlight. It contains glass and a sealed lead acid battery. • Only replace bulb with type indicated in specifications (12 volt, H3 75 watt quartz halogen). •...
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 4 CHARGING/RECHARGING THE SPOTLIGHT This unit is shipped in a partially charged state. Charge unit BEFORE first use using the 120 Volt AC Charger for 20-30 hours or until the green Battery Status LED flashes. Charge after each use until green LED flashes. Charging/Recharging Using the 120 Volt AC Charger and a Standard Household Extension Cord (not included) Plug a standard North American 120 volt AC extension cord (not included) into the 120 Volt AC Charger on the...
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 5 Using the Built-In Carry Lanyard The Carry Lanyard may be used to store or carry the Spotlight. Adjust the slide on the cords to keep the Lanyard secure around the supporting object. CARE AND MAINTENANCE All batteries lose charge with time, especially when they are warm.
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 6 12. Connect the bulb power wire to the red power wire. 13. Tighten the retaining screw on the flange. 14. Place the reflector in position in the body of the spotlight. 15. Replace the rubber “O” ring in the groove around the perimeter of the reflector. 16.
SL212B ManualEN 101607.qxp 9/26/08 1:10 PM Page 7 Accessories Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1 - 8 0 0 - 5 4 4 - 6 9 8 6 . WA R N I N G : The use of any accessory not recommended for use with this tool could be hazardous.