Assembly; Features - Homelite UT10552 Operator's Manual

KNOW yOUR CHAIN SAW
See Figure 1.
Before attempting to use this product, familiarize yourself
with all operating features and safety rules.
CHOKE LEVER
The choke lever opens and closes the choke valve in the
carburetor. Positions available include FULL CHOKE, HALF
CHOKE, and RUN.
COMbINATION WRENCH
A combination wrench tool is provided for use when per-
forming various maintenance procedures. On-board storage
keeps the tool handy at all times.
FRONT HANd GUARd / CHAIN bRAKE
The chain brake is designed to quickly stop the chain from
rotating. When the front hand guard/chain brake is pushed
toward the bar, the chain should stop immediately. The chain
brake does not prevent kickback.
GUIdE bAR
The factory-equipped guide bar has a small radius tip that
offers a somewhat lower kickback potential.
UNPACKING
This product has been shipped completely assembled.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-242-4672 for assistance.
PACKING LIST
Chain Saw
Scabbard
Combination Wrench
2-Cycle Engine Oil
Operator's Manual
Case

FEATURES

LOW KICKbACK SAW CHAIN
The low kickback saw chain helps minimize the force of a
kickback reaction by preventing the cutters from digging in
too deeply at the kickback zone.
PRIMER bULb
The primer bulb pumps fuel from the fuel tank to the car-
buretor.
SAFE-T-TIP ANTI-KICKbACK NOSE GUARd
The SAFE-T-TIP Anti-Kickback Nose Guard is an attach-
ment provided on the end of the guide bar to prevent the
chain on the end of the guide bar from contacting the
wood.
THROTTLE LOCK
The throttle lock feature allows you to start the chain saw
without having to continuously hold the throttle trigger.
THROTTLE TRIGGER
The throttle trigger is used for starting the chain saw, and
also for controlling chain rotation.

ASSEMbLy

WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
NOTE: The chain saw has been fully factory tested. It is
normal to find some slight oil residue on the saw. Read
and remove all hang tags and store with the Operator's
Manual.
Page