Filling - Duracraft DH-830 SERIES Owner's Manual

NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
• Select a firm, level, flat location - at least six inches (15 cm) from any wall
for proper air flow (Fig. 1). Place the humidifier on a water-resistant sur-
face, as water can damage furniture and some flooring.
The manufacturer will not accept responsibility for property damage caused
by water spillage.
• Remove the water tank by grasping handle and
pulling straight up. Set aside (Fig. 1).
• Remove the Natural Cool Moisture™ filter from
the base before filling the unit with water (Fig.
2). Soak filter in a sink full of cool water to help
reduce mineral build up and place back in the
humidifier while wet. DO NOT SQUEEZE OR
WRING OUT THE NATURAL COOL MOIS-
TURE™ FILTER. To help extend the life of your fil-
ter repeat this step each time you fill your
humidifier.
• Turn the Water Tank upside down so that the Fill
Cap is facing up; unscrew the Fill Cap by turn-
ing it counter-clockwise
• Fill the Water Tank with COOL tap water (Fig. 3).
Distilled water is not necessary as the water is fil-
tered by the Natural Cool Moisture™ filter. DO
NOT USE HOT WATER. Doing so may damage the
humidifier.
• Replace the fill cap by turning it clockwise
DO NOT OVER TIGHTEN. Turn the Water Tank
right-side up.
NOTE: WHEN CARRYING THE FILLED WATER TANK
PLEASE USE THE HANDLE AND PLACE YOUR
OTHER HAND UNDER THE TANK FOR ADDITION-
AL SUPPORT.
and set aside.
Fig. 1
Fig. 2
Fig. 3
.
SET UP

FILLING

HANDLE