Bosch B26FT series Operating And Installation Instructions page 26

en
Problem
Drawers can only be
closed with great
difficulty.
The water filter symbol is
flashing.
The ice maker is not
making enough ice
cubes or the ice cubes
are deformed.
The ice maker is not
making ice cubes.
Very little or no water is
dispensed from the
water dispenser.
The dispensed water is
not cold.
The water is cloudy.
There are particles
floating in the water or
suspended in the ice
cubes.
26
Possible cause
The drawer has not been inserted correctly.
The drawer rails are dirty.
The filter cartridge is old.
After replacing the filter cartridge, the water
filter symbol was not reset.
The appliance or ice maker was just recently
switched on.
A large amount of ice has been taken out.
Water pressure is too low.
The filter cartridge is clogged or old.
The ice maker is switched off.
The appliance is not being supplied with
water.
The water connection line has kinks in it.
Water pressure is too low.
The ice cube container is not inserted
correctly.
The water connection is installed incorrectly.
The filter cartridge is clogged or old.
Water pressure is too low.
The shut−off valve is not open all the way.
The water connection line has kinks in it.
The appliance was just recently installed.
The water has been in the lines for an
extended period of time and has adjusted to
the room temperature.
Air or air bubbles in water.
The first time the water flows through the filter
cartridge, it may contain carbon dust from the
filter cartridge.
Suspended particles are formed by mineral
deposits when water is frozen and then
allowed to thaw.
Corrective action
Insert the drawer correctly.
Clean the drawer rails.
Replace the filter cartridge.
Reset the water filter symbol.
It takes approx. 24 hours before it starts making
ice.
It takes approx. 24 hours before the ice storage
bin is full again.
Have the water pressure checked.
Replace the filter cartridge.
Switch on the ice maker.
Have a qualified technician check the water
connection.
Shut off the water supply. Straighten out the
kinks. Have damaged water connection lines
replaced with original manufacturer parts.
Have the water pressure checked.
Insert the ice cube container correctly.
If the water connection is not installed correctly,
this can cause low water pressure and can
damage the appliance.
Replace the filter cartridge.
Have the water pressure checked.
The shut−off valve is open all the way.
Shut off the water supply. Straighten out the
kinks. Have damaged water connection lines
replaced with original manufacturer parts.
It takes approx. 12 hours for the water to cool
down.
Fill and discard the first 15 glasses of water.
This is normal when using the water dispenser for
the first time and will disappear after a short
period of time.
These suspended particles are not harmful!
They will disappear after a short period of time.
These suspended particles are not harmful!
This occurs naturally in the water supply.