LG WT-H800 Service Manual page 20

3
• The pulsator rotates for
8 seconds to detect the
laundry load.
• Then the WATER
LEVEL and the amount
of Detergent to be
used will be shown and
water will be supplied.
4
4
4
4
Close the lid
5
• Water will be let in • When the wash
again 2 minutes program ends, the
after the wash has chime will sound
started to for 10 seconds
supplement the before the Power
water the laundry goes off goes off
has absorbed. automatically.
6
6
6
6
Finish
• If water is already in the tub, or putting
6
wet laundry into the tub before starting will
increase the WATER LEVEL.
• With lightweight bulky loads, WATER
LEVEL can be set low.
• Changes to Water Temperature
(HOT/COLD) and wash level are possible
during operation.
(refer to page 14)
• When setting the WATER LEVEL manually,
7
do not set below level number 6 in order to
prevent damage to the woollen clothes.
• Washing with HOT water may damage the
laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.
• In order to avoid damage to laundry, the
spin cycle may appear slow.
This also avoids wrinkles and clothing may
still contain some water. This is normal.
• When static pressure of water is more
7
than 2kg/cm
will be within 19min.
7
7
19
Caution & Note
2 , the QUICK WASH course