Advertisement
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth. (Fig 1)
Figure 1
Fountain Top
Tube
Water
Pump
Switch
Base Power Cord
Rocks
Platform
Base
Adaptor
4
Figure 2
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
2. Familiarize yourself with the pump. The switch located at the front of the pump controls the
pump speed. The speed is indicated by a plus (+) and minus (-) sign. To increase the speed,
move the switch slowly downward in the direction of the plus sign. You will hear a click as the
switch moves to each speed level. At its highest speed level, the switch will cease to move
any further. To decrease the pump speed, move the switch upward toward the minus sign.
Similarly, at its lowest speed, the switch will cease to move any further (Fig 2).
NOTE: It is recommended the pump be set at its highest speed during assembly and later
adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed
setting.
3. Insert the tube into the pump. (Fig. 3)
4. Set the fountain top onto the base aligning the straight edge of the platform with the straight
edge of the inside of the base. (Fig. 4)
5. Fill base with clean water. Add enough water so that the platform is submerged. (Fig. 5)
Figure 3
Tube
Pump
Figure 4
Line up straight edge
Minimum Water Level
Flow Control Valve
(+) faster water
output
(-) slower water
output
Figure 5
Platform
Water Level
5
Advertisement
