Conair 20-piece HC200WXCSC Instructions For Care And Use page 13

taper lever up as far as it will go. To increase
cutting length, slowly push lever down. If you
push to the lowest position, it will leave hair
about the same length as the short attachment.
Because a different cutting edge is used in
each setting, the taper lever lengthens the
life of your blades.
Packed-in hair can slow down any clipper.
To remove hair without removing the
blades, do what the professionals do:
keeping the clipper on, quickly push the
taper lever back and forth from "close" to
"longer" cut a few times.
If you do this after every clipping, especially
with heavy hair cutting, the blades should
remain free of cut hair. If clipper stops cutting
and this action doesn't help, check the
blades. If they've become dull, replace
them. For new blades, send cheque or
money order for $5.00 plus $2.50 for
postage and handling to:
Conair Consumer Products Inc.
156 Parkshore Drive
Brampton, Ontario L6T 5M1
Close Cut
Longer
Cut