Table of Contents
Advertisement
Note: Type the name of the third-party DDNS provider into your browser, and
it will be retained. If your camera's default http Port number is 80, you must
change it to another number. For example: http://reotest1.dyndns.org:8999
7.5 Alarm, Mail and FTP Service Settings
Alarm Service Settings - You can configure the Alarm Service Settings to
receive and send emails based on specific IP camera events. You can receive an
Alarm Notification email containing images taken during an alarm phase.
In the Alarm Service Settings window, check the boxes for Send Alarm
Notification by Mail and Upload Image on Alarm to enable these features.
Mail Service Settings – In this window you can configure your email
information for receiving IP camera system emails. You should fill in the
following information:
Sender: This IP camera device uses the sender mailbox to send emails.
Receiver: Indicates the email address to receive email from the Sender. You can
set up to 4 receiver mailboxes.
SMTP Server: The SMTP server for the sender mailbox.
Need Authentication: If the Sender mailbox needs authentication, check this box
and type in the
SMTP User name and Password.
Mail test: After configuring your Mail settings, and click Submit. After you have
done this, click on the Test button. The below image shows the Mail test results.
44
Gmail is also set the same way. Simply fill in the correct SMTP Sever address,
User name and Password.
receive an error message after clicking on TEST, recheck the information you
entered to ensure it was all correct. Make the necessary corrections and click on
TEST again. Below are some of the error messages you may receive:
1.
Cannot connect to server.
2.
Network error. Please try later.
3.
Server error.
4.
Incorrect user or password.
5.
Sender is denied by the server. You should re-authenticate the user and
try again.
6.
Receiver is denied by the server. Your server's anti-spam privacy software
could be causing a block.
7.
Message is denied by the server. Your server's anti-spam privacy software
could be causing a block.
8.
Server does not support the authentication mode used by the device.
Report Internet IP by Mail: At the bottom of the Mail Service Settings window
there is a check box for Report Internet by IP Mail. If this box is checked, you will
IP100 Manual
If you
45
Advertisement
Table of Contents
