Advertisement
Figure 5. Installing a Reference 6513cs woofer in a deck.
T
I
WEETER
NSTALLATION
Reference 6513cs tweeters are easy to install. Each is
housed in a surface-mount enclosure with grille and is
equipped with an attached color- and terminal-keyed wire
pigtail. For custom installations, each tweeter includes a
flush-mount kit that features an adjustable firing angle.
S
-M
I
URFACE
OUNT
NSTALLATION
Refer to Figure 6 (above) for correct orientation of the sur-
face-mounting plate. A 7.9 mm (
required to pass tweeter wires and pre-attached termi-
nals. Make sure each proposed hole will not extend beyond
the boundary of the tweeter enclosure.
1. At each chosen site, use the mounting plate (or mount-
ing template) to mark locations of mounting holes and
a feed-through hole for speaker wires.
2. Drill 3.2 mm (
1
⁄
") holes for mounting screws.
8
3. Drill 7.9 mm (
5
⁄
") holes to create passages for wires.
16
O
WNER
5
⁄
") diameter hole is
16
'
M
A
I
S
ANUAL
ND
Figure 6. After installing the surface-mount plate, push the
Reference 6513cs tweeter onto the mounting plate to snap it
into place.
4. Fasten each mounting plate to its site with supplied
#8 x 19 mm (
3
⁄
") screws.
4
5. Route the tweeter's pigtail wire through each feed-
through hole and attach it to the yellow terminal-
keyed wires from the crossover and make the connec-
tions at each pigtail end.
6. Push the wires into the opening and carefully press
each tweeter onto the mounting plate until it snaps
into place.
G
NSTALLATION
UIDE
...continued on next page
7
Advertisement
