Table of Contents
Advertisement
Step 2
Assemble the frame
You will need: left frame, right frame, two nylon
washers, two 1/4-20 x 1/2 inch bolts and a 7/16 inch
wrench.
Note - Work on carpeted area (on grass, or on one of
the boxes) to protect the finish during frame
assembly.
Put the frame pieces so the leg tabs are up. Put the
right frame to your right and left frame to your left.
Figure 1.
Slip the two frame halves together with the tabs
inside, until the tabs of the right frame are inside the
left frame and the holes align. Figure 1 (a).
Slip washers over bolts; insert and tighten bolts. (If
you try to insert a bolt and there are no holes, you
have the left frame turned the wrong way. Turn the left
frame around.) Figure 1 (b).
Figure 1
(a)
(b)
Step 3
Continue frame assembly
You will need: frame assembly, two side frames,
four 1/4-20 x 1/2 inch bolts, four nylon washers
and a 7/16 inch wrench.
Assemble one side frame onto the leg tabs of the
right frame, and the second side frame onto the leg
tabs of the left frame. Make sure the anchoring base
plates are facing in toward each other. The tabs must
be on the inside of the frames when the joints are
closed.
Add washers, then bolts. Do not fully tighten these
bolts. You will tighten them once the base is
anchored. Figure 2 (a).
Turn frame assembly right side up.
Anchoring base
plates are facing in
Do not fully tighten
these bolts
14
(a)
Figure 2
Advertisement
Table of Contents
