Box Contents; Safety Precautions; Setup - Directed Electronics iPod Cradle Kit User Manual

Box Contents

Unpack your iPod Cradle Kit carefully and make sure that
everything listed below is present:
1. iPod cradle
2. IR remote control
3. 5 insert pads
4. User's Manual

Safety Precautions

Take the following precautions to keep the unit in proper
working order:
❍
Set up must be performed according to this manual.
Directed Electronics is not responsible for issues aris-
ing from set up not performed according to the proce-
dures in this manual.
❍
Do not use the unit where it will be exposed to high lev-
els of humidity, moisture, or dust.

Setup

Note: Refer to the assembly diagram on the next page
for the installation of the iPod cradle, insert pad, and iPod.
1. Remove, if installed, the Sportster from the docking
cradle.
Desktop Docking Station User Guide—© Directed Electronics, all rights reserved
Desktop Docking Station
2. Remove the Sportster cradle from the Docking station
by gently pushing the release tabs inward towards
each other, and gently lifting the cradle out. If the cra-
dle has been permanently attached to the docking sta-
tion, remove the two small silver screws before remov-
ing the cradle.
3. Install the iPod cradle into the Docking Station's base
by gently pushing it in until you hear the release tabs
click.
4. Select the insert pad to use with your iPod. Install the
insert pad into the iPod cradle. (Each insert pad's
usage is marked with the iPod model.)
5. Install your iPod into the cradle.
6. Remove the plastic battery slip from the remote control
supplied with the iPod Cradle Kit. The battery compart-
ment must be opened to remove this slip. The instruc-
tions for opening the battery compartment are located
on the back of the remote. The battery used is a 3.0V
CR2025.
3