Learn As You Build - Ramsey Electronics PG13 Instruction Manual

RAMSEY "LEARN-AS-YOU-BUILD" ASSEMBLY STRATEGY
Be sure to read through all of the steps, and check the boxes as you go to be
sure you didn't miss any important steps. Although you may be in a hurry to see
results, before you switch on the power check all wiring and capacitors for
proper orientation. Also check the board for any possible solder shorts, and/or
cold solder joints. All of these mistakes could have detrimental effects on your
kit - not to mention your ego!
Kit building tips:
Use a good soldering technique - let your soldering iron tip gently heat the
traces to which you are soldering, heating both wires and pads simultaneously.
Apply the solder to the iron and the pad when the pad is hot enough to melt the
solder. The finished joint should look like a drop of water on paper, somewhat
soaked in.
Mount all electrical parts on the top side of the board provided. The top side is
clearly marked with the model and revision numbers of the kit; you can't miss it.
This is the side that has few traces on it and has the silkscreen on it. When
parts are installed, the part is placed flat to the board, and the leads are bent on
the backside of the board to prevent the part from falling out before soldering
(1). The part is then soldered securely to the board (2-4), and the remaining
lead length is then clipped off (5). Notice how the solder joint looks on close up,
clean and smooth with no holes or sharp points (6).
•
PG13 16