I. ASSEMBLING DOOR
(1) When mounting the door assembly to the oven
assembly, be sure to adjust the door assembly
parallel to the chassis. Also adjust so the door has no
play between the inner door surface and oven frame
assembly. If the door assembly is not mounted
properly, microwaves may leak from the clearance
between the door and the oven.
J. REMOVING THE VENTILATION MOTOR
(1) Remove the mounting plate by loosening mounting
plate screws (1 or 2 screws) securing it to the back
plate. (See Figure 16)
(2) Remove MOUNT, ALL loosening one screw
loosening one screw securing the ventilation Motor
and back plate. (See Figure 17-a)
Figure 17-a
Space
(1 or 2 screws)
Figure 16
MOUNT, ALL
MOUNT, ALL
(1 or 2 screws)
(3) Carefully pull the ventilation motor ASS'Y out of the
microwave oven. (See Figure 17-b)
K. REPLACING THE HUMIDITY SENSOR
(1) Remove the sensor by removing two screws
securing it to the air duct. (See Figure 18)
(2) Mount the new humidity sensor to the air duct.
7-9
Figure 17-b
Figure 18