LG MH-1355M Service Manual page 28

G. REMOVING HIGH VOLTAGE
TRANSFORMER (FIG. 18)
(1) Disconnect the wire leads from the trans-
former to the magnetron and H.V. Capacitor.
(2) Remove four screws securing the H.V. Trans-
former to the base plate.
(3) Tilt the top of the H.V. Transformer towards
you, pull slightly and lift it up.
H. REMOVING TURNTABLE MOTOR
(FIG. 19, 20, 21)
(1) Remove the turntable, the rotating ring and the
turntable shaft. (Fig. 19)
(2) Lay the set down on its back.
(3) Remove the turntable motor cover of the
baseplate. The turntable motor cover is easily
removed by pinching the six parts with a wire
cutter. (Fig. 20)
(4) Disconnect the lead wires from the turntable
motor terminals.
(5) Remove two screws securing the turntable
motor to the oven cavity assembly.
(6) Lift the turntable motor.
Fig. 19
(7) After repairing the motor, rotate the removed
turntable motor cover. (Fig. 20)
(8) Fit the turntable motor cover's projecting part
to the base plate's slit. (Fig. 21)
NOTE:
1. Remove the lead wire from the turntable motor
VERY CAREFULLY with long nose pliers.
2. Be sure to grasp the connector, and not the
wires when removing.
3. In assembling, insert the slit part of turntable
motor cover and secure it by using two screws.
Fig. 20
– 28 –
H.V. TRANSFORMER
H.V. CAPACITOR
BRACKEY
H.V. DIODE
H.V. CAPACITOR
Fig. 18
Fig. 21