Honeywell CL30XC Owner's Manual page 17

DRAINING AND CLEANING THE WATER TANK
•
Turn the power "off" and disconnect the air cooler from the power
supply.
•
Move the unit to a location where it can be drained. Remove the
cap from the water drain plug and allow the tank to empty (see
parts description on page 7).
•
Once the tank is empty, unlock the latches on both sides and lift
off the cooler top section as shown in the figure and place it
vertically on the floor. Be careful not to bend the water pickup tube
that hangs below the unit.
•
Refill the water tank with clean water and drain it completely.
•
Clean the water tank with detergent or a damp cloth and rinse it
thoroughly.
•
Place the unit top carefully on the tank and lock the latches.
•
Refill the water tank with clean water, up to the maximum level.
•
Plug into the power supply and turn unit on.
CLEANING THE FILTER AND HONEYCOMB
•
Turn off the unit, and unplug the power cord from wall outlet.
•
Rotate the unit facing the back panel, and locate the Rear Grill
Removal Screws (refer page 7., #19). Remove both the screws with
a screw driver.
•
Pull the rear grill panel upwards, untill it is completely removed.
•
Now, the carbon filter and honeycomb media can be seen. Clean
both the filters with clean cloth to remove all the dust & dirt
particles.
•
Once the cleaning has been completed, assemble the unit as
described above.
•
Plug into the power supply and turn unit on.
CLEANING & MAINTENANCE
Latches
Water Pick Up Tube
Water Drain
Plug
Open Screws
Honeycomb
Carbon Filter
Back Panel
15