Sunbeam Precision EM0700 Instruction Booklet page 15

Advanced Settings
Recalibration of the EM0700
Note: Recalibration will change all previous settings on the grinder
1. Close hopper closure arm.
2. Purge beans through the grinder.
3. Turn the operation dial to the 'off' position.
4. Disconnect the plug from the power socket.
5. Remove the bean hopper by turning anticlockwise.
To recalibrate for a coarser grind
6. Take note of your current grind setting
position.
7. Rotate the grind adjustment collar to
position 15 on the grind settings, see
figure 12.
8. Lift the recalibration release lever and
remove grind adjustment collar, see figure
13 and 14.
9. To make the grind coarser, reposition the
collar to setting 10 on the grind settings.
10. Re-assemble the collar by pressing down
the front and then the rear ensuring two
clicks are heard.
11. Return the grind setting back to your
original grind setting position. Your grind
will now be coarser.
12. Attach the hopper, open the hopper
closure arm and turn on the grinder.
Note: Check the new setting delivers the
required grind before use.
14
To recalibrate for a finer grind
Note: The grinder is factory set for fine
grinding. Only re-calibrate finer if the 0
setting does not achieve the desired grind
fineness.
6. Rotate the grind adjustment collar to
position 15 on the grind settings,
see figure 12.
7. Lift the recalibration release lever and
remove grind adjustment collar, see figure
13 and 14
8. To make the grind finer, reposition the
collar to setting 17 on the grind settings.
9. Re-assemble the collar by pressing down
the front and then the rear ensuring two
clicks are heard.
10. Attach the hopper and run the grinder to
ensure smooth operation.
Caution: Re-calibrating too fine may cause
burrs to collide resulting in a metallic
grinding noise. If this occurs turn off the
grinder and move to a coarser setting (a
setting towards 30) or re-calibrate for a
coarser grind.
11. Open hopper closure arm and adjust
grind settings to deliver required grind
size.
Note: Further tuning may be required.