MSI MS-7758 (v1.x) Manual page 48

BIOS Setup
▶ Parallel(LPT) Port
Ths tem allows you to enable/ dsable the parallel port.
▶ Parallel(LPT) Port Settngs
Select an address and correspondng nterrupt for the parallel port.
▶ Devce Mode
Select a devce mode for the parallel port.
▶ Hardware Montor
Press <Enter> to enter the sub-menu.
▶ CPU Smart Fan Target
Controls CPU fan speed automatcally dependng on the current temperature and
to keep t wth a specfic range. If the current CPU temperature reaches the target
value, the smart fan functon wll be actvated.
▶ SYS Fan1 Control
These tems allow users to select how percentage of speed for the SYSFAN1.
▶ CPU/ System Temperature, CPU FAN/ SYS FAN 1 Speed
These tems show the current status of all of the montored hardware devces/ com-
ponents such as CPU temperature/ system temperature and the few fans' speeds.
▶ Power Management Setup
Press <Enter> to enter the sub-menu.
▶ EuP 2013
Energy Usng Products Lot 6 2013 (EUP) reduces power consumpton when system
s off or n standby mode.
Note: When enabled, the system wll not support RTC wake up event functons.
▶ Restore after AC Power Loss
Ths tem specfies whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power Off]
[Power On]
[Last State]
▶ Wake Up Event Setup
Press <Enter> to enter the sub-menu.
▶ Wake Up Event By
Settng to [BIOS] actvates the followng fields, and use the followng fields to set the
wake up events. Settng to [OS], the wake up events wll be defined by OS.
▶ Resume By RTC Alarm
The field s used to enable or dsable the feature of bootng up the system on a
scheduled tme/date.
▶ Date/ HH:MM:SS
If Resume By RTC Alarm s set to [Enabled], the system wll automatcally resume
(boot up) on a specfic date/hour/mnute/second specfied n these fields (usng the
<+> and <-> to select the date & tme settngs).
2-8
Always leaves the computer n the power off state.
Always leaves the computer n the power on state.
Restore the system to the status before power falure or nterrupt
occurred.