MSI MS-7758 (v3.x) Manual page 48

BIOS Setup
▶ Parallel(LPT) Port Configuraton
Press <Enter> to enter the sub-menu.
▶ Parallel(LPT) Port
Ths tem allows you to enable/ dsable the parallel port.
▶ Parallel(LPT) Port Settngs
Select an address and correspondng nterrupt for the parallel port.
▶ Devce Mode
Select a devce mode for the parallel port.
▶ Hardware Montor
Press <Enter> to enter the sub-menu.
▶ CPU Smart Fan Target
Controls CPU fan speed automatcally dependng on the current temperature and
to keep t wth a specfic range. If the current CPU temperature reaches the target
value, the smart fan functon wll be actvated.
▶ SYS Fan1/ Fan2 Control
These tems allow users to select how percentage of speed for the SYSFAN1/ SYS-
FAN2.
▶ CPU/ System Temperature, CPU FAN/ SYS FAN 1/ SYS FAN2 Speed
These tems show the current status of all of the montored hardware devces/ com-
ponents such as CPU temperature/ system temperature and the few fans' speeds.
▶ Intel(R) Smart Connect Configuraton
Press <Enter> to enter the sub-menu.
▶ Intel(R) Smart Connect Technology
Ths feature can update applcatons (ex. emal and socal networks) by perodcally
wakng your system from sleep mode. And you do not have to wat for the applcatons
to update when you wake up the system. Ths tem s used to enable/ dsable the
Intel smart connect technology.
▶ Power Management Setup
Press <Enter> to enter the sub-menu.
▶ EuP 2013
Energy Usng Products Lot 6 2013 (EUP) reduces power consumpton when system
s off or n standby mode.
Note: When enabled, the system wll not support RTC wake up event functons.
▶ Restore after AC Power Loss
Ths tem specfies whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power Off]
[Power On]
[Last State]
2-8
Always leaves the computer n the power off state.
Always leaves the computer n the power on state.
Restore the system to the status before power falure or nterrupt
occurred.