What To Do If - Zanussi ZEI6640XBA User Manual

What to do if...

Problem
You cannot activate the appliance or
operate it.
A Sound operates and the appliance
deactivates.
A sound operates when the appliance
is deactivated.
The appliance deactivates.
The residual heat indicator does not
comes on.
The Automatic Heat Up function does
not operate.
The heat setting changes between two
levels.
The sensor fields become hot.
comes on
comes on
and number comes on.
comes on
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch one
sensor field.
• The Child Safety Device or the Lock operates. See the chapter Operating
instructions.
• There is water or fat stains on the control panel. Clean the control panel.
You put something on one or more sensor fields. Remove the object from the
sensor fields.
You put something on the
The cooking zone is not hot because it operated only for a short time. If the
cooking zone should be hot, speak to the service centre.
• There is still residual heat on the cooking zone. Let the cooking zone be-
come sufficiently cool.
• The highest heat setting is set. The highest heat setting has the same pow-
er as the Automatic Heat Up function.
The Power management is activated. See the section Power management.
The cookware is too large or you out it too near to the controls. Put large
cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and activate it
again.
• No cookware on the cooking zone. Put cookware on the cooking zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the cooking
zone. Move cookware to a smaller cooking zone.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Disconnect
the fuse from the electrical system of the house. Connect again. If
on again, speak to the service centre.
There is an error in the appliance, because a cookware boils dry. The protec-
tion against become too hot for the cooking zone operates. The Automatic
Switch Off operates.
Deactivate the appliance. Remove the hot cookware. After, approximately 30
seconds activate the cooking zone again.
residual heat indicator can stay. Let the cookware become sufficiently cool
and check it with the section Cookware for the induction cooking zone.
Possible cause and remedy
. remove object from the sensor field.
should go out of the display,
comes
11