Table of Contents
Advertisement
Lamp
(continued)
5
Install the lamp cover and fix it using screws.
• To prevent burn, install the lamp cover and secure it using the screws.
• Do not turn on the power with lamp cover removed.
• Whenever the lamp is replaced, reset the total operation time of the lamp. Do not reset if
the lamp has not been replaced.
• Do not perform resetting without changing the lamp, as this can cause lamp breakage.
2. Reset the lamp time
If you have replaced the lamp after the lamp replacement time had expired, perform the procedure
explained below within 10 minutes after the power is turned on. The power will turn off automatically
when the 10-minute period expires.
POSITION ON
3
2
1) Press the RESET button on projector for 3 seconds or remote control TIMER
button for 3 seconds and display the total lamp used time.
• When accumulated operation time of the lamp reaches 1700 hours, the
following display will appear at the bottom of the screen.
2) Press the RESET button on projector or remote control MENU ON button
during displaying the lamp used time.
3) Select the "0" on the screen using the MENU (
Message table
On-screen display
The following messages are displayed on the screen.
MESSAGE
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
THE POWER WILL TURN
OFF AFTER * Hr.
Blinking of
CHANGE THE LAMP
NO INPUT IS DETECTED
SYNC IS OUT OF RANGE
*1 This message are not displayed after 3 minutes.
But this message are displayed when you turn on the power again.
*2 It is possible to again turn on the power, however the power will go off after about 10 minutes.
LASER
1
RESET
RIGHT
MENU ON
MOUSE ON
BLANK
TIMER
RGB
VIDEO
INPUT
The lamp has been in service for long. Replacement with a new lamp is
recommended. The lamp will go off automatically when the lamp replacement
time is exceeded. *1
The total lamp service time will exceed the lamp replacement time in * hours.
The lamp will go off automatically when the lamp replacement time is
exceeded. Replace with a new lamp before that. *1
The asterisk (*) indicates the number of hours remaining before the lamp goes
off automatically.
The total lamp service time has exceeded the lamp replacement time. The lamp will go
off automatically about 10 minutes after it starts blinking. Replace with a new lamp.*2
Signal is hot input. (See page 20, 21)
The horizontal frequency of the input signal exceeds the range of the projector,
it cannot be displayed. (See page 21, 22)
STANDBY/ON
1, 2
RESET
) button or DISK PAD.
Action
Lamp cover
Screw
INPUT
MUTE
MENU
3
LAMP 1700 h
←
LAMP 1700
0
CANCEL
31
Advertisement
Table of Contents
