Bounty Hunter Sharp Shooter II Owner's Manual page 5

ASSEMBLY
Assembling your Sharp Shooter II
Metal Detector is easy and requires
no tools. Just follow these steps:
G
1 Using the supplied bolt and
knurled knob, attach the
searchcoil to the lower stem.
G
2 Press the button on the upper end
of the lower stem and slide the
lower stem into the upper stem.
Adjust the stem to a length
that lets you maintain a com-
fortable upright posture, with
your arm relaxed at your
side. Maintain the searchcoil
about 1 inch above the
ground as you sweep.
G
3 Wind the searchcoil cable
around the stem. Leave
enough slack in the cable to let
you adjust the coil when you
are hunting
ground. Then tighten the knob
at the end of the searchcoil.
Note: To adjust the coil,
simply loosen the knob.
G
4 Insert the coil's plug into the
matching connector on the
control housing. Be sure the
holes and pins line up correctly.
Caution:
• Do not force the plug in.
Excess force will cause damage.
• To disconnect the cable, pull
out the plug. Do not pull on
the cable.
on uneven
5