Maintenance & Adjustments - Westerbeke 12B TWO Operator's Manual

Marine diesel
Hide thumbs Also See for 12B TWO:
Table of Contents

Advertisement

MAINTENANCE AND ADJUSTMENTS
Introduction
This section contains a scheduled preventive maintenance program and several adjustment procedures the
owner/operator can perform without the benefit of sophisticated and expensive tools and instruments,
Preventive Maintenance
Perform the preventive maintenance in accordance with the schedules listed in the following paragraphs,
Adherence to these schedules will ensure the equipment is maintained in the best possible condition and
that it will perform to expectations, Those items marked by an asterisk
(*)
are recommended to be per-
formed by an authorized dealer or distributor.
Daily (before each use)
1, Check the oil sump level. Maintain the oil level at or near upper level mark on dipstick,
2, Check the coolant level in the plastic recovery tank, Maintain this level at or above the level marked
ADD,
3, Check the transmission's lubricant level, and add additional lubricant as needed,
4, Visually inspect the unit; check for loose bells, chafed or broken wires, loose brackets and fittings,
damaged hoses, loose clamps, and other equipment not properly secured, This check should include
the propeller shaft coupling to the transmission's output flange,
5, Check the fuel supply, Fill tank(s) with a good grade of No, 2 dieselluel, if required,
6, Check the primary filter/water separator. Drain and service as required, (A primary iilterjwater separator
is optional, but strongly recommended,)
7, Check the engine's gauges or lights for proper oil pressure, operating temperature, and starting bat-
tery charging voltage once the engine is operating,
8, Check the alternator's output gauge (if installed) for proper DC voltage,
Monthly
Check the condition of the zinc anode in the heat exchanger's sea water circuit Clean or replace the anode,
as required, Keep the area inside the heat exchanger clean 01 zinc anode debris,
Servicing After Initial
50
Hours 01 Operation
1, Change the engine's lubrication oil and oil filter,
2, Replace the fuel filter element in the electric fuel lift pump and in the optional water/sediment separator,
if a separator has been installed,
Westerbeke
Diesel Engines
60

Advertisement

Table of Contents
loading

Table of Contents